Compressed Air Moisture Separators Introduction

Compressed air moisture separator is used to separate implants such as water and oil condensed in compressed air, so that compressed air is preliminary purification.

The working principle of the compressed air moisture separator is: when the compressed air enters the oil -water separator, it generates sharp changes in flow and speed, and then relies on the inertia to separate the density than the oil droplets and water droplets with a large density than compressed air.

After the compressed air enters the separator shell from the entrance, the airflow is first blocked by the barrier to fold back down, and then rises upwards to generate ring rotation. In this way, the water droplets and oil droplets are separated from the air and sink from the bottom of the shell under the influence of centrifugal force and inertial force. Regularly open the bottom valve to discharge oil droplets. The preliminary purified air was sent from the exit to the gas storage tank.

Another gas -liquid separation system, the inside uses stainless steel wire mesh compatriot, and the shell is welded with a steel tank structure. The principle is to use the organic combination of cyclone and stainless steel wire mesh. At the same time, the mechanisms such as direct interception, inertia collision, Brown diffusion and condensation can effectively remove dust, water, and oil mist in compressed air. The amount of water removal, large oil removal, and a wide range of adaptation.