Introduction to the method of installing flange compressed air filter

　　The filter element of the flange compressed air filter is made of high-quality imported filter material, which has high filtration efficiency, small initial pressure drop and long service life. The shell has been sprayed with epoxy resin to prevent corrosion. It has strong environmental adaptability, is not easy to corrode, and is durable. The air in all compressed air systems comes from the atmosphere. The air contains a large amount of dust, water vapor, incompletely combusted hydrocarbons and bacteria. After compression, the concentration increases several times.
　　The lubrication system of the flange compressed air filter will also produce contaminants such as wear particles and oil stains. This oil is acidic and is a low-quality oil that does not have any lubricating effect. The rust of the compressed air distribution system can also cause pollution to the compressed air. All these dust, oil and water mix together to form a harmful corrosive sludge, which will quickly wear pneumatic equipment, block valves, and corrode pipelines, resulting in: air leakage, tool and equipment damage, production stagnation, and increased maintenance costs , Product scrap, health and safety are threatened. Solution: The flange compressed air filter can effectively remove these harmful impurities in the compressed air. As long as it is installed in the system and used with a refrigeration dryer or suction dryer, it can provide compressed air that meets various quality requirements.
　　The following is an introduction to the method of installing the flange compressed air filter:
　　1. Select the installation location for the filter and the gas-water separator, and be sure to relieve the pressure of the pipeline before installation.
　　2. Install the product and the gas-water separator vertically on the pipeline, and confirm the flow direction according to the arrow on the filter. The threaded filter needs to use raw material tape or sealing material to ensure the seal. The maximum working pressure, maximum working temperature and filter element have been marked On the outer casing of the filter.
　　3. In order to make it easy to replace the filter element, pay attention to reserve a disassembly position for the threaded filter and the flange filter.